Update:
Applying the Film
Once you are satisfied that the film will fit the window,apply a generous amount of application solut...
Applying the Film
Once you are satisfied that the film will fit the window,apply a generous amount of application solutionwith a squeeze, or trigger spray bottle, and peel the protective layer off the tint film, and spray the exposed adhesive as well. Now comes the fun part:
- With the help of your assistant, carefully place the adhesive side of the film over the window, starting at the bottom edge. While working upwards avoid crinkles, as many bubbles as you can, and pressing too hard, since the adhesive is sensitive to pressure. If you press too hard at this stage, the film will stick to the window, and you will have to start over.
- If you are satisfied that the film is in place, use a rubber squeegee to push the film firmly onto the glass by using even strokes, starting from the middle and working outwards. At this point it is important to wet the outside surface of the film to provide lubrication for the squeegee, and while there are many solutions that work for this, a good idea is to use a few drops of chemical free dish-washing liquid diluted in a pint or so of water in a trigger spray bottle.
- Continue to wet the film while working the air bubbles and application solution out from under the film, but avoid pressing to hard, or changing the direction of the squeegee in mid-stroke. Remember that the film has not yet fully bonded with the glass, but it will bond progressively more as the solution is removed from under it. Make sure you are able to access the corners and edges of the window- if you cannot, use a piece cut off from a second squeegee to make sure you get the film to stick around the edges as well as in the middle.
- Apply progressively more pressure on the squeegee as air bubbles are worked out, and by the time all the application solution and bubbles are removed, the film should be firmly bonded to the glass, with no wrinkles, no trapped air bubbles, and no gaps around the edges.
- Repeat the process for the other windows, and allow at least 48 hours for the adhesive to cure before you either wash, or roll your windows up or down.
Amber Zhang Ms.
Foreign trade
Zhejiang Ruico Advanced Materials Co., Ltd. (Stock No.873233)
Add: No.188, Liangshan Road, Linghu Town, Nanxun District, Huzhou City, Zhejiang Province, China 313018
Phone: +86 (572) 2903236
Fax: +86 (572) 2905222
Wechat: 15534631339
Website: www.ruicoglobal.com
Email: [email protected]